User`s guide

14 • Installation
2.6 Device Installation for Windows Systems
Once Windows 95/98/2000 has started, the Plug and Play function of Windows
system will find the new NuDAQ/NuIPC cards. If this is the first time the
NuDAQ/NuIPC cards are running on your Windows system , you will be
prompted to input the device information source. Please refer to the “Software
Installation Guide” for step-by-step installation procedures.
2.7 Connectors Pin Assignment
The PCI-9111 comes equipped with two 20-pin insulation displacement
connectors - CN1 and CN2 and one 37-pin D-type connector - CN3. CN1 and
CN2 are located on board with CN3 located at the rear plate.
CN1 is used for digital input signals, CN2 for digital output signals and CN3 for
analog input and output, extended digital I/O and timer/counter signals. Pin
assignments for each connector is illustrated in Figure 3 ~ Figure 5.