User`s guide

10 • Installation
2
Installation
This chapter describes how to install the PCI-9111. Follow the steps carefully.
• Check what you have (section 2.1)
• Unpacking (section 2.2)
• Check the PCB and jumper locations (section 2.3)
• Setup jumpers (section 2.4)
• Installing the hardware (section 2.5)
• Installing the software drivers for windows (section 2.6)
• Daughter Board connections (section 2.8)
The PCI-9111 automatically configures the IRQ, port and BIOS addresses.
Therefore, it is not necessary to configure these addresses, hence avoiding
any addressing conflicts.