User`s guide

22 • ACLD-9178
4
ACLD-9178
This chapter describes how to install and use the ACLD-8125.
4.1 Introduction
The ACLD-9178 is a universal screw terminal panel with convenient
connection points for 20-pin flat cable connector.
The ACLD-9178 is designed for establishing external signal conditioning
circuits. For example, you can easily construct a low-pass filter, attenuator
or current-to-voltage converter by adding resistors and capacitors onto
the reserved circuit pads.
4.4.1 Features
The ACLD-9178 screw terminal board provides the following features:
l Low cost universal screw terminals
l Signal conditioning circuits built-in.
l Table-top mounting using nylon standoffs
l 40 terminal points for two 20-pin flat cable connectors.
l Controlled through TTL/CMOS signals or digital output ports
of any ACL series board
4.2 Installation
To install and operate the ACLD-9178, please follow the steps:
Ø Check what you have in the box