User`s manual

Getting Started 39
Figure 3-5: PMC Installation 2
3.4 HDD Installation on Main Board
A slim-type 2.5-inch HDD can be mounted on the cPCI-6841 or
cPCI-6841-2. If a HDD is pre-installed, this section may be
skipped.
1. Screw the provided standoffs onto the HDD and attach
the included 44-pin IDE cable.
2. Place the HDD onto the board as shown and connect the
IDE cable to the socket. Tighten the four screws from the
bottom side of the main board to secure the HDD in to
place.
3. Press the IDE cable into the shape shown to avoid inter-
ference when inserting and removing the board.
Please refer to the illustrations shown below to install your 2.5”
hard disk.