User`s manual

Getting Started 37
Figure 3-3: Memory Installation
3.3 PCI Mezzanine Card (PMC) Installation
(cPCI-6841 only)
The PMC slot is designed for 5V and/or universal PCI interfaces.
The PMC site is keyed to prevent users from installing a 3.3V only
PMC module.
To install the PMC modules:
1. Prepare an ESD protected area including an anti-ESD
table and ESD strap. Attach the ESD strap to your wrist
and connect the end of the ESD strap to ground of the
anti-ESD table.
2. Remove the PMC blanking plate from the front panel.
3. Install the PMC module onto the board by aligning the
PMC sockets and voltage selection keys and then push-
ing down firmly on the module.