Specifications
Notice Page
NOTICE
No part of this document may be reproduced, transmitted, transcribed, stored in a retrieval system, or
translated into any language or computer language, in any form or by any means, electronic, mechanical,
magnetic, optical, chemical, manual, or otherwise, without the prior written permission of ADLINK
Technology, Incorporated.
DISCLAIMER
ADLINK Technology, Incorporated makes no representations or warranties with respect to the contents of
this manual or of the associated ADLINK products, and specifically disclaims any implied warranties of
merchantability or fitness for any particular purpose. ADLINK shall under no circumstances be liable for
incidental or consequential damages or related expenses resulting from the use of this product, even if it has
been notified of the possibility of such damages. ADLINK reserves the right to revise this publication from
time to time without obligation to notify any person of such revisions. If errors are found, please contact
ADLINK at the address shown at the bottom of this notice.
Audience
This reference manual is for the person who designs computer related equipment, including but not limited
to hardware and software design and implementation of the same. ADLINK Technology, Inc. assumes you
are qualified in designing and implementing your hardware designs and their related software into your
prototype computer equipment.
ii Reference Manual LittleBoard 800
TRADEMARKS
CoreModule and the Ampro logo are registered trademarks, and ADLINK, Little Board, LittleBoard,
MightyBoard, MightySystem, MilSystem, MiniModule, ReadyBoard, ReadyBox, ReadyPanel,
ReadySystem, and RuffSystem are trademarks of ADLINK Technology, Inc. All other marks are the
property of their respective companies.
REVISION HISTORY
ADLINK Technology, Incorporated
5215 Hellyer Avenue
San Jose, CA 95138-1007
Tel. 408 360-0200
Fax 408 360-0222
www.adlinktech.com
© Copyright 2006, 2007, 2008, 2009 ADLINK Technology, Incorporated
Revision Reason for Change Date
A, A Initial Release Mar/07
A, B Added 1.0 Ghz power measurements Nov/07
B, A Corrected pin 1 on J30 and pin 5 on J2;
corrected 800 MHz power
measurements in Table 2-6; updated
Southbridge from ICH4-M to ICH4;
added Figure 2-7; added PCI-to-ISA
Bridge Mapping to Ch 4; added pinouts
to Ch 3; updated audio chip to ALC203
Mar/09