User`s manual

Signal Connections 41
By default, the OUT and DIR are set to differential line driver
mode.
The wiring diagram below illustrates the OUT and DIR signals on
the 4 axes of PCI-8164 card.
NOTE When the pulse output is set to open collector output
mode, OUT- and DIR- transmits OUT signals. The sink
current must not exceed 20 mA on the OUT- and DIR-
pins. By default, pin 1-2 of the jumper is shorted.
USAGE Short pin 2-3 of the jumper and connect OUT+/DIR+ to a
470 ohm pulse input interface’s COM of driver. See the
following figure.
Output Signal
For differential line driver
output, close breaks
between 1 and 2 of:
For open collector out-
put, close breaks
between 2 and 3 of:
OUT1- J1 J1
DIR1- J2 J2
OUT2- J3 J3
DIR2- J4 J4
OUT3- J5 J5
DIR3- J6 J6
OUT4- J7 J7
DIR4- J8 J8