User`s manual

14 Getting Started
2.4 Drive Bay Access
To install the required hardware in the two 5.25” drive bays, follow
the procedure below:
1. Remove the 16 screws fastening the chassis lid and lift it
off of the cPCIS-3320.
2. Remove the three screws fastening the drive bay
bracket to the internal chassis structure as shown in the
figure below. Remove the bracket from the chassis, undo
the four screws attaching the blanking cover to the drive
bay bracket, and remove the blanking cover.
Figure 2-5: 5.25” drive bay access.
3. Install the necessary hardware into the drive bay
bracket, replace the bracket into the chassis, and fasten
the screws attaching it to the internal chassis structure.
4. Make the necessary cable connections and replace the
chassis lid.