User`s manual

Getting Started 9
2 Getting Started
This chapter describes the unpacking procedure of the sub-sys-
tem and installation procedures for CompactPCI boards, power
supply units (PSUs) and drive bays.
2.1 Shipping Contents
Check the shipping carton for any damage. If the shipping carton
and contents are damaged, please notify the dealer for a replace-
ment. Retain the shipping carton and packing material for inspec-
tion by the dealer. Obtain authorization before returning any
product to ADLINK.
Check that the following items are included in the package. If there
are any missing items, please contact your dealer:
X One cPCIS-3320 Series platform
X This User’s Manual
X Accessory Kit (includes N. American or European power
cord, air filter and spare screws)
2.2 CompactPCI Computing Blade &
PSU Installation
The CompactPCI connectors are rigid and require careful handling
when inserted and removed. Improper handling of cards can eas-
ily damage the backplane.
The host board slot is red, peripheral slots are gray, and PSU slots
are green. The Chassis Management Module (CMM) slot is also
gray, but the pin connector of the CMM is different than that of the
peripheral board. Be certain to insert each module into the correct
type of slot. The slot left of the PSU slots shown in the figure below
is for CMM use only.
Host board slots have obvious indicators (e.g. red card guide rail,
triangle mark enclosing the slot number on the backplane) A host
board can only be installed in a host board slot. Do not insert a
host board into any other slot, or insert any peripheral card into a
host board slot.