User`s guide

42 • Driver Installation
7. You will then see a warning panel about Third Party Drivers, Click yes to
finish the installation.
8. Once the installation is completed, the system must be shut down and
restarted for the new drivers to take effect.
Note: After installing the VGA/AGP drivers, and you discover the driver
does not work probably. This may be caused by not installing
Windows NT service pack beforehand. Ensure to install Windows
NT service pack 6 or higher version to enable AGP capability.
4.1.3 Display Driver for Windows 2000
The following section describes the normal procedures for installing the
display driver for Windows 2000.
Installing the Drivers for Windows 2000
1. Boot Windows 2000.
2. The driver is included in the ADLINK CD. Locate the following directory:
X:\CHIPDRV\VGA\69000\win2K.
3. Click the "Start" button, then select the "Settings" tab and click on
"Control Panel".
4. Click on the "Display" icon to start the Display Properties window.
5. Click on the "Settings" tab, and then click on the "Advanced..." button.
6. Select the "Adapter" tab, then the "Properties" button on the same
screen.
7. Select the "Driver" tab, and then click the "Update Driver" button.
8. An Upgrade Device Driver Wizard window will appear, click Next>.
9. Select Display a list of ... and click Next>. The next window shows a list
of hardware models.
10. Click the "Have Disk..." button and select the location of the driver files
X:\CHIPDRV\VGA\69000\win2K and click “ok”.
11. Select the Device Driver “Chips and Technologies (Asiliant) 69000”
and click “Next”
12. Click “Yes” to continue the installation
13. To complete the installation, click “Finish”
14. The system must be shut down and re-booted for the new drivers to take
effect