User`s guide

36 • Getting Started
To install memory on to DM1 socket, please follow the following procedures
carefully:
1. Ensure the cPCI system is power off. Remove the cPCI-6765(A) from
chassis.
2. Hold the SO-DIMM and have its edge connector at a slight angle then
insert into DM1 socket. Note that the SO-DIMM is keyed.
3. Push the SO-DIMM into the connector horizontally until it snaps into
place and is firmly seated.
4. Check to make sure the SO-DIMM is inserted securely.
3.3 HDD and CF Installation
The cPCI-6765(A) can be installed with a slim-type HDD mounting bracket
where a 2.5 inches IDE drive can be seated. The HDD can be pre-installed
when the equipment is shipped or optionally by the user. However, if users
wish to install the HDD, the HDD mounting kit is requited. Please contact
your nearest dealer or ADLINK sales representatives.
You may purchase off-the-shelf 2.5-inch HDD from the market. Due to space
limitation and for better ventilation consideration, low profile 2.5-inch HDD no
thicker than 9.5mm is recommended.
3.3.2 CF Installation for cPCI-6765(A)
The CompactFlash Card (or called CF storage card) is widely applied to
digital consumer devices like PDA, Digital Camera and MP3 player.
However, the CF features anti-shock, anti-vibration, better environment
tolerance, low power consumption, small form factor and higher reliability,
plus, it has been also widely accepted in the industrial and embedded
application field. Because them CF unit occupies the same location as the
HDD. One or the other can be installed but not both on the front board.
For more information about this option, please contact your nearest dealer or
ADLINK sales representatives.