User`s guide

Jumpers and Connectors • 19
2.2 Configuration
The cPCI-6765(A) has been designed for maximum flexibility and can be
configured for specific applications. Most configuration options are selected
through the BIOS Setup utility however some options cannot be software
controlled and are configured with jumpers or by other means beside
software
The cPCI-6765(A) contains a push-button switch on the faceplate and several
banks of jumper pin on the front and rear board. The switches and jumpers
are listed and briefly described in the "Switch Cross-Reference" table below.
Switch Cross-Reference Table
Switch Function
SW1 Reset
JP1 Clear CMOS Content
S1, S2. S3, S4 Switch to set LAN for Front or Rear
Access
R33, R34, R38, R49 Resistors to set PMC VIO
JP2 ~ JP5 (cPCI-R6765) COM2 RS-232/422/485/485+ Selectable
Table 3: Switch Cross-Reference Table
2.2.1 SW1 (Reset)
SW1 is a push-button on the front panel of the cPCI-6765(A). Pressing SW1
issues a hard reset and will reset the system