User`s manual

Installation 29
3.3.4 Powering Up the System
The PXIS-2719 is equipped with a 90 VAC to 264 VAC universal
power supply unit that does not require input voltage selection.
To power on the chassis, complete the following steps:
1. Connect one end of the supplied power cable to the
power connector located at the rear side of the chassis.
2. Plug the other end of the AC power cord to a properly
grounded wall socket or power strip.
3. Switch the main power switch to the ON (I) position.
4. Push the standby power switch. The Power LED (blue)
lights up immediately, and Fan LED (green) and Temper-
ature LED (amber) also light up 3 seconds later.
Main Power
Switch
AC Power
Connector