Specifications

Introduction 13
cPCI-6840
X Bus master IDE controller supports two ultra ATA-100 inter-
faces.
Z Primary IDE is on SBC with 44-pin IDE connector. A 2.5
inches IDE HDD can be mounted on the lower PMC site.
Z Secondary IDE ports is on J5 for RTM extension.
X Four USB ports with USB Spec Rev. 2.0 compliant.
Z USB 0, 1 are on the front panel.
Z USB 2, 3 are on the RTM.
Z USB ports support 0.5A@5V for peripherals with individ-
ual over-current protection.
X Two SATA ports on RTM with data transfer rates up to 150
MB/s.
X Two RS-232 serial ports. COM1 on the front with RJ-45 type
connector. COM2 is on the J3 and can be accessed on the
RTM.
X PS2 keyboard / mouse connector on the front panel and
RTM.
Front Panel LED Indicators and Reset
X Four LEDs on the front panel including storage access LED
(RED), Power LED (GREEN), hot-swap status (Blue), and
Watchdog timer LED (Yellow).
X Flush tact switch for system reset.
IPMI Interface
X Supports PICMG 2.9 secondary system managing bus.
Implements IPMI functions as defined in the IPMI specifica-
tion v 1.5
X Atmel ATMEGA128L Baseboard Management Controller
(BMC)
Real -Time Clock and Nonvolatile Memory
X Build into Intel® 6300ESB southbridge RTC.
X Battery-backed memory is used for BIOS configuration
X Separate 3V coin cell CR2032 battery used for RTC and
nonvolatile memory
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com