User`s manual

46 IPMI Interface
8.1 Command List
The following table shows the command list supported by the
MMC. The “IPM Controller Req” column indicates if a particular
command is required by the relevant specifications.
Command
IPMI/PICMG
Spec Ref.
NetFn CMD IPM Controller
Req
IPM Device “Global” Commands
Get Device ID 17.1 App 01h Mandatory
Cold Reset 17.2 App 02h Optional
Warm Reset 17.3 App 03h Optional
IPMI Messaging Support Commands
Send Message 18.7 App 34h Optional
BMC Watchdog Timer
Reset Watchdog Timer 21.5 App 22h Mandatory
Set Watchdog Timer 21.6 App 24h Mandatory
Get Watchdog Timer 21.7 App 25h Mandatory
Event Commands
Set Event Receiver 23.1 S/E 00h Mandatory
Get Event Receiver 23.2 S/E 01h Mandatory
Platform Event (a.k.a. “Event
Message”)
23.3 S/E 02h Mandatory
Sensor Device Commands
Get Device SDR Info 29.2 S/E 20h Mandatory
Get Device SDR 29.3 S/E 21h Mandatory
Reserve Device SDR
Repository
29.4 S/E 22h Mandatory
Get Sensor Reading Factors 29.5 S/E 23h Optional
Set Sensor Hysteresis 29.6 S/E 24h Optional
Get Sensor Hysteresis 29.7 S/E 25h Optional
Set Sensor Threshold 29.8 S/E 26h Optional
Get Sensor Threshold 29.9 S/E 27h Optional
Set Sensor Event Enable 29.10 S/E 28h Optional
Get Sensor Event Enable 29.11 S/E 29h Optional
Rearm Sensor Events 29.12 S/E 2Ah Optional