Specifications

Chapter 3 Hardware
CoreModule 720 Reference Manual 25
Note: The shaded table cells denote power or ground.
Table 3-7 describes the pin signals of the USB2 and USB3 header, which consists of 10 pins in two rows,
with odd/even (1, 2) pin sequence, and 0.079" (2mm) pitch.
Note: The shaded table cells denote power or ground.
Table 3-8 describes the pin signals of the USB4 and USB5 header, which consists of 10 pins in two rows,
with odd/even (1, 2) pin sequence, and 0.079" (2mm) pitch.
Note: The shaded table cells denote power or ground.
9
USB_GND0 USB0 Ground
10
USB_GND1 USB1 Ground
Table 3-7. USB2 and USB3 Interface Pin Signals (J14)
Pin # Signal Description
1
USB-PWR_2 USB2 Power – VCC (+5V +/-5%) power goes to the port through an on
board fuse. Port is disabled if this input is low.
2
USB-PWR_3 USB3 Power – VCC (+5V +/-5%) power goes to the port through an on
board fuse. Port is disabled if this input is low.
3 CONN_USB2_N USB2 Port Data Negative
4 CONN_USB3_N USB3 Port Data Negative
5 CONN_USB2_P USB2 Port Data Positive
6 CONN_USB3_P USB3 Port Data Positive
7
USB_GND2 USB2 Ground
8
USB_GND3 USB3 Ground
9
USB_GND2 USB2 Ground
10
USB_GND3 USB3 Ground
Table 3-8. USB4 and USB5 Interface Pin Signals (J13)
Pin # Signal Description
1
USB-PWR_4 USB4 Power – VCC (+5V +/-5%) power goes to the port through an on
board fuse. Port is disabled if this input is low.
2
USB-PWR_5 USB5 Power – VCC (+5V +/-5%) power goes to the port through an on
board fuse. Port is disabled if this input is low.
3 CONN_USB4_N USB4 Port Data Negative
4 CONN_USB5_N USB5 Port Data Negative
5 CONN_USB4_P USB4 Port Data Positive
6 CONN_USB5_P USB5 Port Data Positive
7
USB_GND4 USB4 Ground
8
USB_GND5 USB5 Ground
9
USB_GND4 USB4 Ground
10
USB_GND5 USB5 Ground
Table 3-6. USB0 and USB1 Interface Pin Signals (J12) (Continued)