User`s guide

Installation

•

Installation

This chapter describes how to install the ACL-8111. The following list

shows the installation procedures:

1. Unpacking and check what you have

2. Check the PCB and the location of jumper and switch

3. Setup the jumpers according to the system and applications setting

4. Installation the external termination boards

5. Wiring with signals according to the connector pin assignments

2.1 Unpacking

The ACL-8111 card contains sensitive electronic components that can

be easily damaged by static electricity.

The card should be done on a grounded anti-static mat. The operator

should be wearing an anti-static wristband, grounded at the same

point as the anti-static mat.

Inspect the card module carton for obvious damage. Shipping and

handling may cause damage to your module. Be sure there are no

shipping and handing damages on the module before processing.

After opening the card module carton, extract the system module and

place it only on a grounded anti-static surface component side up.

Again inspect the module for damage. Press down on all the socketed

IC's to make sure that they are properly seated. Do this only with the

module place on a firm flat surface.

Note: DO NOT APPLY POWER TO THE CARD IF IT HAS BEEN

DAMAGED.