Technical data

Installation
Operating manual 743-221-01 version 01.0 - 09/2013
51
6.3.2 Holding device for the template set
Fig. 29: Holding device
During the transport the holding device (1) for the template set (2) is un-
derneath the table top.
1. Remove the fastening screws.
2. Rotate the holding (1) device by 180°.
3. Attach the fastening screws again.
6.3.3 Attaching the operating panel OP 3000
Fig. 30: Fixation operating panel OP 3000
1. Attach angle (2).
2. Attach the operating panel (1) onto angle (2).
཰
ཱ
(1) - Holding device
(2) - Template set
(1) - Control panel (2) - Angle
཰
ཱ