Technical data

Installation
50
Operating manual 743-221-01 version 01.0 - 09/2013
6.3 Attaching the machine parts removed for shipping
Some parts of the machine had to be removed or shifted in their position
for shipment. These parts have to be attached correctly before start of
work.
6.3.1 Thread reel holder
The thread reel holder is loosely added for shipment. In order to connect
the machine to the power supply from the top, the connection cable can
be run through the tube (2) of the thread reel holder.
Guide the compressed air supply pipe upwards through the second bore
hole in the table top and then attach it to the thread reel holder with cable
ties.
Fig. 28: Attaching the thread reel holder
1. Insert the thread reel holder (2) into the bore hole of the table top.
2. Fix it with nut (4) underneath the table top.
3. Align the reel plate (3) and the unwinding brackets (1) parallel to the
rear table edge. Reel plate (3) and the unwinding brackets (1) have to
point into the same direction.
཰
ཱི
ི
ཱ
(1) - Unwinding bracket
(2) - Thread reel holder
(3) - Reel plate
(4) - Nut