Technical data

Installation

Operating manual 743-221-01 version 01.0 - 09/2013

6.2.2 Removing the transport securing devices

Before installing the sewing unit, you have to remove all the securing de-

vices.

All movable parts have to be unlocked:

• Positioning table

• Sewing drive

• Smoother and bundle clamp

• Positioning table

If the sewing unit has to be transported to another place, you have to at-

tach the securing devices again.

6.2.3 Setting the working height

The working height is adjustable between 850 and 1250 mm (measured

to the upper edge of the table plate).

Fig. 27: Setting the working height

1. Loosen screws (1) to (4).

2. Set the unit to the desired height and level it out.

3. Re-tighten screws (1) to (4) again.

Be careful when loosening the attachment screws.

The sewing unit may keel over when the tubular

feet of the frame are pulled out.

CAUTION

(1) - Screw

(2) - Screw

(3) - Screw

(4) - Screw

཰

ཱ

ཱི

ི