Technical data

Operating the sewing unit
40
Operating manual 743-221-01 version 01.0 - 09/2013
5.15 Sewing
In order to start sewing, certain requirements have to be fulfilled. Below
you will find the description of a typical sewing process.
Before sewing start, all dart lengths have to be marked on the folding plate
(1) with adhesive tape (flat and as thin as possible).
Fig. 20: Sewing process
1. Turn on the machine at the main switch.
2. Start the reference run by pressing the “OK” key.
 The machine is ready for operation after carrying out a reference run.
It is in its initial position.
3. Select a program in the main menu,
 5.14 Setting the control unit, p. 34.
 The selected program is activated.
4. Put the workpiece with both hands around the edge of the folding plate.
Caution: Danger of injury!
Only mark the dart length with the sewing machine
being switched off.
ATTENTION!
Material damage
Do not slide in the folding table without sewing material on it. The
friction surfaces of the template set could get damaged.
ATTENTION!
(1) - Folding plate
཰