Technical data

Operating the sewing unit
34
Operating manual 743-221-01 version 01.0 - 09/2013
5.14 Setting the control unit
At this point only the settings needed for sewing will be mentioned.
Additional settings on the technician level are described in the  Service
Instructions.
The control unit is operated via the operating panel OP3000,  4.2 Soft-
ware description, p. 16.
After switching on the machine the firmware and software versions will
briefly be displayed. After this start the reference run by pressing the
“OK“ key,  p. 17.
After the reference run the main menu is displayed.
5.14.1 Functions in the main menu
Fig. 18: Main menu
Main menu - Top line
• Select the desired parameter with the arrow keys (◄,►).
The activated parameter is highlighted.
• Enter the desired value by using the arrow keys (▼,▲).
The value is directly applied and memorized for the particular program.
Program selection
Program number entry
Range of values: 1 - 20
Seam length
Seam length entry in mm
Range of values: 19 - 150
Important: The seam length can only be entered if the light barrier
(
 p. 35) is disabled.
Stitch length
Stitch length entry in mm
Range of values: 0.5 - 3.0
(1) - Program selection
(2) - Seam length
(3) - Stitch length
(4) - hook thread counter
(5) - Seam counter
(6) - Submenu
(7) - Switching additional functions on/off
ཱཱིུུ཰ཱི
ྲྀ