Technical data

Operating the sewing unit
32
Operating manual 743-221-01 version 01.0 - 09/2013
5.13 Setting the insertion depth of the folding table
The first needle entry in the material should be as close as possible to the
fold edge.
In order to achieve an evenly slim dart point with material of varied thick-
ness, the machine is equipped with a fine adjustment.
Up to 7 different insertion depths can be set by using the stops (4).
Fig. 17: Setting the insertion depth
Setting the insertion depth
1. Release the lever (4).
2. Slide the folding table on its guiding a little to the front.
3. Set one of the set screws (3) (7 pieces) to the desired insertion depth.
4. Turn the adjustment knob (2) to the desired insertion depth (until it stops).
5. Slide the folding table back to the rear.
The adjustment knob (3) has to abut on the stop (1).
6. Tighten the lever (4) again.
Caution: Danger of injury!
Turn off the main switch.
The insertion depth may only be set or altered with
the sewing machine being switched off.
ATTENTION!
(1) - Stop
(2) - Adjustment knob
(3) - Set screw
(4) - Lever
཰
ི
ཱ
ཱི