Technical data

Operating the sewing unit
Operating manual 743-221-01 version 01.0 - 09/2013
29
5.11 Changing the template set
A template set adapted to the desired sewing shape has to be inserted. It
allows for the sewing of straight and curved darts, pleats or, on request,
also special customer requirements can be realized,  2.3 Optional
equipment, p. 8.
Fig. 13: Changing the template set
Removing
the template set
1. Turn the hand wheel until the needle stands in the 2nd position (UDC).
2. Slide the template set (2) into the left end position.
3. Turn the handle (1) about 90° in counter-clockwise direction.
4. Lift the template set (2) at the left side and carefully detach it from the
transport carriage.
5. Remove the template set.
Inserting
the template set
1. Turn the hand wheel until the needle stands in the 2nd position (UDC).
2. Move the transport carriage to the left end position.
3. Bear the template set (2) with the right side carefully onto the transport
carriage.
4. Turn the handle (1) 90° in counter-clockwise direction and lay the tem-
plate set completely onto the transport carriage.
5. Turn back the handle (1).
 The template set is locked and safely fastened to the transport car-
riage.
Caution: Danger of injury!
Turn off the main switch.
The template set may only be changed with the
sewing machine being switched off.
ATTENTION!
(1) - Handle
(2) - Template set
(3) - Control cam
(4) - Hold-down cylinder
཰
ི
ཱ
ཱི