Technical data

Operating the sewing unit
20
Operating manual 743-221-01 version 01.0 - 09/2013
5.4 Needle thread monitor
Fig. 6: Needle thread monitor
At needle thread rupture, a rupture message will appear on the display
and the machine stops.
1. Turn the machine off the main switch.
2. Remove the unfinished workpiece.
3. Thread in the thread again,  5.2 Threading in the needle thread, p. 18.
4. Turn on the machine at the main switch.
5. Start a new sewing cycle.
Caution: Danger of injury!
Turn off the main switch before threading in the
needle. A restart is only possible after switching
the main switch off and on again.
ATTENTION!
཰
(1) - Thread monitor