Installation Manual

8
ASSEMBLY
STEP 7
Install 2-AAA batteries in the remote control.
Operate remote control to verify base functions
properly. If base does not operate, see the
Troubleshooting section.
STEP 8
Lower base to flat position.
STEP 9
Remove any protective film from Micro-Hook™
strips.
STEP 10 (OPTIONAL)
Carefully insert base into case good or bed frame, if
applicable.
POWER CORDS MUST NOT INTERFERE WITH
ANY ADJUSTABLE BASE MECHANISMS.
DO NOT WEAVE CORDS THROUGH BASE
STRUCTURE.
WARNING
!
DUE TO RISK OF INJURY, TWO ADULTS
ARE REQUIRED TO HANDLE AND MOVE
ADJUSTABLE BASE.
WARNING
!
STEP 5
Plug electrical power cord into power brick. Plug
brick power cord into base motor cable. Secure
connection using cable latch (FIGURE 5). Note: Align
pins before inserting plugs.
Plug electrical power cord into power outlet. Note: An
electrical surge protection device is recommended
(not included).
ELECTRICAL
POWER CORD
BASE
MOTOR
CABLE
POWER BRICK
BRICK
POWER
CORD
FIGURE 5
MOTOR
CABLE
Note: Your base may be equipped with
an in-line switch (pair button) as part of
the electrical power cord located near the
end of the power cord. This can be used
in lieu of the learn switch on the control
box.
CABLE
LATCH
IN-LINE SWITCH /
PAIR BUTTON
STEP 6
Gently rotate over so base is resting on its legs.