Installation Manual

REMOTE CONTROL PROGRAMMING - 1 REMOTE TO OPERATE 1 BASE

STEP 1

Plug base into power outlet.

STEP 2

Simultaneously press and hold both the HEAD

DOWN and FOOT UP buttons on the remote control

(FIGURE 8). While holding these buttons, press and

hold the LEARN button on the control box (FIGURE

9) or the PAIR button on the in-line switch (FIGURE

10), as equipped. Hold until you hear an audible

sound, then release all buttons.

Note: Your base may be equipped with an in-line

switch (pair button) as part of the electrical power

cord located near the end of the power cord. This

can be used in lieu of the learn switch on the

control box.

STEP 3

Operate the remote control to verify the base

functions correctly.

HEAD

DOWN

FOOT UP

FIGURE 8

FIGURE 10

PAIR

BUTTON

IN-LINE

SWITCH

ELECTRICAL

POWER CORD

FIGURE 9

LEARN

BUTTON

CONTROL BOX