User Manual

Prodigy™ 2.0 Adjustable Base Owners Manual 99301584-c
8
STEP 7
Install batteries in remote control (3-AAA, included) (FIGURE 3). Note:
Make sure batteries are properly oriented. Briefl y activate all functions of the
base with the remote control to verify all features are in working order. If
base does not operate, refer to the Troubleshooting section of this manual.
STEP 8
Return base to the level position.
INSTALLATION
PRESS IN ON TAB AND LIFT
OUT TO REMOVE BATTERY
COMPARTMENT DOOR.
INSERT TABS IN TAB SLOTS
AND SNAP IN TO REPLACE.
FIGURE 3
TAB
BATTERY
COMPARTMENT
DOOR
POSITIVE (+)
END
POSITIVE (+)
END
STEP 6
Plug electrical power cord into a working, grounded electrical outlet.
Note: An electrical surge protection device is recommended (not included).
STEP 5
Remove the plastic packaging from the base frame. Carefully rotate the
adjustable base over to position the base so it is resting on its legs (FIGURE 2).
FIGURE 2
4-PORT CHARGING HUB
(located on each side of
base, for charging low-
voltage devices only)
HEAD END
OF BASE