User Manual
Prodigy™ 2.0 Adjustable Base Owners Manual 99301584-c
13
REMOTE CONTROL PROGRAMMING
(
1 remote control - 1 base)
Program One Remote to Operate One Base - perform the
following numbered procedure.
STEP 1
Unplug the adjustable base electrical power
cord from power source. Wait 30 seconds, then
plug back in.
STEP 2
Remove the battery compartment door from the
remote control (FIGURE 10).
STEP 5
On the remote control, press and hold the learn
switch (FIGURE 10)
until the underbed lighting
goes off.
STEP 6
Operate remote control to verify programming.
One remote control is now programmed to
operate one base.
FIGURE 10
LEARN
SWITCH
BATTERY
COMPARTMENT
DOOR
STEP 3
Position base on its side. Locate the control
box, attached to the underside of the base
(FIGURE 11).
STEP 4
Using a pointed object, push the learn button
in two times in rapid succession (FIGURE 11).
The underbed lighting will come on.
FIGURE 11
LEARN
BUTTON
CONTROL
BOX