Instructions / Assembly

5/16 Nut driver

G (4)

1in. Hex Head Self-tapping

Screws for Striker Bar

03-AG72LTP 2016-04-11

PG.1

1in.x1in.x33in. Telescoping Bar

3/4

in.x

3/4

in.x33in. Telescoping Bar

Gate Latch Kit

1in. Round Head Wood Screws

(16 for 2x4 clips, 4 for gate latch)

2in. Flat Head Wood Screws

(for Spreader Bars into 2x4’s)

Not neccessary for every hole

AG72LTP ADJUSTABLE GATE FRAME ASSEMBLY

PAGE 1
AG72LTP ADJUSTABLE GATE FRAME ASSEMBLY 5/16 Nut driver 1in.x1in.x33in. Telescoping Bar 3/4in.x3/4in.x33in. Telescoping Bar Gate Latch Kit 1in. Hex Head Self-tapping G (4) Screws for Striker Bar 1in. Round Head Wood Screws (16 for 2x4 clips, 4 for gate latch) 2in. Flat Head Wood Screws (for Spreader Bars into 2x4’s) Not neccessary for every hole 03-AG72LTP 2016-04-11 PG.
PAGE 2
• Familiarize yourself with the gate hardware frames and instructions • Note that the HINGE SIDE of the frame is marked “HINGE SIDE” and the pre-drilled hole for the TRUSS CABLE is located on the inside of the upper side of the frame, be sure to assemble with this hole at the top of the frame • This frame is designed to open INWARD (into your fenced area), if your application calls for an OUTWARD opening you can adjust the placement of the POST HINGES to the opposite side of the post – see STEP 1.
PAGE 3
bolt head J J J (approximately 2” from the top and bottom receiving tubes) 2” 2” Because it is an adjustable frame, not all predrilled holes on the telescoping bars and vertical frames will line up. 03-AG72LTP 2016-04-11 PG.
PAGE 4
Attach the STRIKER BAR of the Gate Latch Kit (F) to the inside gate frame at the desired height using the 4 HEX HEAD SELF-TAPPING SCREWS (G). Then align the LATCH with the striker bar and attach to post using 1” wood screws. 03-AG72LTP 2016-04-11 PG.
PAGE 5
PAGE 6
PAGE 7
PAGE 8
PAGE 9
PAGE 10
PAGE 11
PAGE 12
PAGE 13