User manual
1. Checking the Contents
Be sure your UCD-100 MKII package was shipped with the following:
1) UCD-100 MKII Professional Rackmount Single CD/USB Player
2) User Manual (this booklet)
3) RCA Cables Stereo Cables
4) Warranty Card
2. Installing the Units
1) The UCD-100 MKII is designed to placed on a flat level surface or installed into a standard 19”
rack mount case or enclosure. When mounting the UCD-100 MKII in a 19” rack be sure to support
the unit by all four screw slots on the face of the unit.
2) Be sure the player is mounted in a well ventilated area where it will not be exposed to direct sunlight,
high temperatures, or high humidity.
3) Try to place the unit as far as possible from TV’s and tuners, as the unit may cause undesirable inter-
ference with such devices.
3. Connections
1) Be sure the power is disconnected.
2) Connect the included RCA cable from your UCD-100 MKII outputs to the inputs on your mixer.
3) Use the Digital Output to connect to MiniDisc, DAT machines, or other device that accepts digital
inputs.
CAUTION:
To avoid severe damage to the unit, be sure the power is off when making connections to the unit.
SET-UP
CAUTION:
• The player will work normally when the main unit is mounted with the front panel within 15 degrees of the
vertical plane If the unit is tilted excessively, disks may not be loaded or unloaded properly.
©American Audio® - www.americanaudio.com - UCD-100 MKII Instruction Manual Page 7
USB INFORMATION:
reader while the USB card reader is still connected to the unit.
SD CARD INFORMATION:
PLEASE NOTE: