User manual

ADJ Products, LLC - www.adj.com - UB 6H User Manual Page 15ADJ Products, LLC - www.adj.com - UB 6H User Manual Page 14
Channel Value Function
1 RED
0 - 255 0% - 100%
2 GREEN
0 - 255 0% - 100%
3 BLUE
0 - 255 0% - 100%
4 WHITE
0 - 255 0% - 100%
5 AMBER
0 - 255 0% - 100%
6 UV
0 - 255 0% - 100%
UB 6H 6 Channel Mode UB 6H ADJ UC IR/Airstream IR Operation
The UC IR infrared remote gives you control of various functions (See
below). To control the fixture you must aim the remote at the front of the fix-
ture and be no more than 30 feet away. To use the ADJ UC IR you must first
activate the fixtures infrared sensor, to activate the sensor please see the
instructions on page 11.
The Airstream IR remote transmitter plugs into the headphone jack of your
iOS phone or tablet. To control your IR fixture you must raise the volume to
the maximum on your iOS phone or tablet and aim the transmitter at the fix-
ture sensor and be no more than 15 feet away. After you have purchased the
Airstream IR transmitters, the app is a free download from the app store for
your iOS phone or tablet. The app comes with 3 pages of control depending
on the fixture you are using. Please see below for IR functions including the
corresponding app page.
Works with App page 1.
STAND BY - Pressing this button will blackout the fixture. Press the button
again to return to the initial state.
FULL ON - Press this button down to fully light up the unit. Press this button
again to return the unit to its last mode of operation.
FADE/GOBO - This button activates fade mode. Use buttons 1-3 to adjust
the fade speed.
“DIMMER +” and “DIMMER -” - Use these buttons to adjust the output in-
tensity.
STROBE - Press this button to activate strobing. Use buttons 1-4 to adjust
the strobe speed. “1” being the slowest, “4” being the fastest. Press this
button again to stop strobing.
COLOR - Press this button to activate color mode. Use buttons 1-9 to find
your desired color.
1-9 - Use buttons 1-9 to select your desired color when color mode is active
or your desired program when show mode is active. Use buttons 1-4 to se-
lect you desired strobe rate when strobing is active.
SOUND ON & OFF - Use the buttons to activate and deactivate sound ac-
tive mode.
SHOW 0 - Press this button to activate show mode. Use buttons 1-9 to
select your desired show. Press this button twice for show 10. Press
button 1 twice for show 11.