User manual

UB 6H Trouble Shooting
Listed below are a few common problems the user may encounter,
with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are
wired correctly (pin 3 is “hot”; on some other DMX devices
pin 2 may be ‘hot’). Also, check that all cables are connected
to the right connectors; it does matter which way the inputs
and outputs are connected.
Unit does not respond to sound:
1. Quiet or high pitched sounds will not activate the unit.
2. Make sure that Sound Active mode is activated.
UB 6H Cleaning
Due to fog residue, smoke, and dust cleaning the internal and exter-
nal optical lenses must be carried out periodically to optimize light
output.
1. Use normal glass cleaner and a soft cloth to wipe down the
outside casing.
2. Clean the external optics with glass cleaner and a soft cloth
every 20 days.
3. Always be sure to dry all parts completely before plugging
the unit back in.
Cleaning frequency depends on the environment in which the fixture
operates (i.e. smoke, fog residue, dust, dew).
Disconnect the unit from its power source. Remove the power cord
from the unit. Use a flat head head screwdriver to remove the fuse
holder. Remove the fuse located inside the fuse holder and replace
with the new fuse. Install the fuse holder and new fuse and secure it.
UB 6H Fuse Replacement
ADJ Products, LLC - www.adj.com - UB 6H User Manual Page 24 ADJ Products, LLC - www.adj.com - UB 6H User Manual Page 25
UB 6H Magnetic Quick Align
Remove Bracket
Magnet
This unit features a magnetic quick align feature which allows
you to connect multiple xtures securely end-to-end. This
feature is exclusively used for when the xtures are used on a
at surface such as a oor or stage for uplighting. To use this
feature, uscrew the thumb screws on both ends of the xture
and remove both brackets. Position the xtures on a at surface
and connect them end-to-end.
Magnet Side