User manual

ADJ Products, LLC - www.adj.com - Stinger II Instruction Manual Page 4
Safety Issues: This unit may “pop” the fuse if the maximum allotted
load of 2 amps is reached.
• To reduce the risk of electrical shock or re, do not expose this unit
rain or moisture.
• Do not spill water or other liquids into or on to your unit.
• Do not attempt to remove or break o the ground prong from the
electrical cord. This prong is used to reduce the risk of electrical
shock and re in case of an internal short. Do not attempt to oper-
ate this unit if the power cord has been frayed or broken.
• Disconnect from main power before making any type of connection.
• Do not remove the cover under any conditions. There are no user
serviceable parts inside.
• Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between this device and a wall.
• Do not attempt to operate this unit, if it becomes damaged.
• This unit is intended for indoor use only, use of this product out-
doors voids all warranties.
• During long periods of non-use, disconnect the unit’s main power.
• Always mount this unit in safe and stable matter.
• Power cords should be routed so they are not likely to be walked
on, pinched by items placed upon or against them.
• Cleaning -The fixture should be cleaned only as recommended by
the manufacturer. See page 21 for cleaning details.
• Heat -The appliance should be situated away from heat sources
such as radiators, heat registers, stoves, or other appliances
(including amplifiers) that produce heat.
• The fixture should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the unit.
C. The unit has been exposed to rain or water.
D. The unit does not appear to operate normally or exhibits a
marked change in performance.
!
!
LASER RADIATION AVOID
DIRECT EYE EXPOSURE
Maximum output <5 mW
Wavelength: 405, 532nm
Class IIIa laser product
This device complies with 21 CFR chapter I,
Subchapter J, or CFR 1040.10 and 1040.11
Stinger II Safety Precautions
ADJ Products, LLC - www.adj.com - Stinger II Instruction Manual Page 19
Stinger II 9 Channel Mode
Channel Value Function
1 SHOW MODE
0 - 9 NO FUNCTION
10 - 44 SHOW 1
45 - 79 SHOW 2
80 - 114 SHOW 3
115 - 149 SHOW 4
150 - 184 SHOW 5
185 - 219 SHOW 6
220 - 255 RANDOM SHOW
2 COLOR MACRO
0 - 9 NO FUNCTION
10 - 198 COLOR CHANGE
199 - 225 COLOR FADE 1
226 - 255 COLOR FADE 2
3 LED STROBE
0 - 9 NO STROBE
10 - 244 LED STROBE SLOW - FAST
245 - 255 SOUND ACTIVE STROBING
Stinger II 2 Channel Mode
Channel Value Function
1 SHOW MODE
0 - 9 NO FUNCTION
10 - 44 SHOW 1
45 - 79 SHOW 2
80 - 114 SHOW 3
115 - 149 SHOW 4
150 - 184 SHOW 5
185 - 219 SHOW 6
220 - 255 RANDOM SHOW
2 SHOW SPEED/SOUND SENSE
0 - 247 SHOW SPEED SLOW - FAST
248 - 255 SOUND ACTIVE