User manual
ADJ Products, LLC - www.adj.com - Stinger II Instruction Manual Page 10
Stinger II Laser Warning Labels
ADJ Products, LLC - www.adj.com - Stinger II Instruction Manual Page 13
Stinger II System Menu
UVSP - UV activation/speed control.
1. Press the MENU button until “UVSP” is displayed, press ENTER.
2. The display will show either “FAST” or “SLOW”. Use the UP and
DOWN buttons to highlight your selection.
3. Press ENTER to conrm.
SLND - This will let you set unit as a master or slave in a
master/slave conguration.
1. Press the MENU button until “SLND” is displayed, press ENTER.
Either “MAST”, “SL 1”, or “SL 2” will be displayed.
2. Press the UP or DOWN buttons until your desired setting is dis-
played, press ENTER to conm.
In a Master/Slave conguration you can set one xture to
Master and then set the next xture to “SL 2”, the xtures will now
have contrast movement to each other.
SOUN - Sound Active mode.
1. Press the MENU button until “SOUN” is displayed, press ENTER.
2. The display will show either “ON” or “OFF”. Press the UP or
DOWN buttons to select “ON” to activate sound active mode, or
“OFF” to deactivate sound active mode.
3. Press ENTER to conrm.
SOSE - In this mode you can adjust the sound sensitiv-
ity.
1. Press the MENU button until “SOSE” is displayed, press ENTER.
2. A number between 0-100 will be displayed. Press the UP or DOWN
buttons to adjust the sound sensitivity. 0 being the least sensitive,
and 100 being the most sensitive.
3. When you have found your desired setting press ENTER to conrm.