Manual

FUNCTIONS:

Fade Time:

1. The amount of time it will take for the dimmer to go from zero output to maximum output

or the amount of time it will take for the DMX signal to go from zero to 255, and vice

verse.

2. Fade time is adjusted through the FADE SLIDER (FIG. 28), which varies from instant to 10

minutes.

SINGLE MODE (FIG.18):

1. All programs will run in sequential order starting with program one.

2. The DIGITAL DISPLAY (FIG. 13A) will display the running program number.

3. All programs will be controlled by the same SLIDER SPEED (FIG. 30).

4. Be sure the audio is disengaged. The AUDIO BUTTON (FIG. 20), green led should be

turned off. The MODE SELECT BUTTON (FIG.10) must be in ‘CHNS SCENES’ to

controll the audio mode.

5. Press the MODE SELECT BUTTON (FIG.10) and select ‘CHNS SCENES.’

6. Press the PARK BUTTON (FIG. 18) to select SINGLE CHASE MODE. A red LED will indicate

this selection.

Mix Mode

1. Will run all programs synchronously

2. All programs can be controlled by the same SLIDER SPEED (FIG. 30), or each

programs speed may be controlled individually (See speed settings page 6).

3. Be sure the audio is disengaged. The AUDIO BUTTON (FIG. 20), green led should be

turned off. The MODE SELECT BUTTON (FIG.10) must be in ‘CHNS SCENES’ to

controll the audio mode.

4. Press the MODE SELECT BUTTON (FIG.10) and select ‘CHNS SCENES.’

5. Press the PARK BUTTON (FIG. 18) to select MIX CHASE MODE. A yellow LED will indicate this

selection.

Display:

1. The 3-DIGIT DIGITAL DISPLAY (FIG. 13A) is designed to display fader percentage or

DMX values.

2. To change between percentage and DMX value: Press and hold the RECORD

BUTTON (FIG. 16). While holding down the record button press the INSERT / % OR 2-255

BUTTON (FIG. 15) to switch between percentage and DMX values.

Blind:

1. This function takes channels temporally out from a chase, when the chase is

running, and gives you manual control over the channel.

2. Press and hold the BLIND BUTTON (FIG. 24) and Tap the FLASH BUTTON (FIG. 7) of

channels you want to temporarily take out of chase.

3. To return to normal chase again press and hold the HOME BUTTON (FIG. 25) and push the

FLASH BUTTON (FIG.7) to the channels you want to return to normal chase.