User manual
ADJ Products, LLC - www.adj.com - Saber Spot GO User Manual Page 7
Saber Spot GO Battery Precautions
BATTERY STORAGE
When storing the battery, it should be stored at room temperature, with a charge of at least 50%. We
recommend that during long periods of storage that the battery be charged every 6 months. Doing
this will prolong the life of the battery and will also make sure that the battery charge does not fall
below the 30% mark.
OTHER CHEMICAL REACTION
Because batteries utilize a chemical reaction, battery performance will deteriorate over time even if
stored for a long period of time without being used. In addition, if the various usage conditions such
as charge, discharge, ambient temperature, etc. are not maintained within the specied ranges, the
life expectancy of the battery maybe shortened or the device in which the battery is used may be
damaged by electrolyte gel leakage. If the batteries cannot maintain a charge for long periods of
time, even when they are charged correctly, this may indicate it is time to change the battery.
BATTERY DISPOSAL
Please dispose of battery according to local regulations.
Saber Spot GO Battery Status & Charging
Battery Status:
This function is used to check the life status of the battery.
Apply power to the fixture and press the MODE button until “Fixture Power” and “XXX%” is displayed.
“XXX%” represents the current battery life.
Battery Recharge: To recharge the battery, plug the supplied power supply into the power input on
the rear of the unit and plug the other end into a matching power supply. When the unit is charging
the charging indicator will glow red. When the unit reaches full charge the charging indicator will glow
green. It takes about 4 hours to reach full charge.