User manual

ADJ Products, LLC - www.adj.com - Saber Spot GO User Manual Page 23

Saber Spot GO Trouble Shooting

Saber Spot GO Cleaning

Listed below are a few common problems the user may encounter, with solutions.

Unit not responding to DMX:

1. Be sure that the wireless channel setting on the unit and the transceiver channel match.

2. Be sure that you are in the correct DMX channel mode.

3. Be sure that the distance between is not to far and that there is no interference with the “line

of sight”.

Due to fog residue, smoke, and dust cleaning the internal and external optical lenses must be carried

out periodically to optimize light output.

1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.

2. Clean the external optics with glass cleaner and a soft cloth every 20 days.

3. Always be sure to dry all parts completely before plugging the unit back in.

Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog

residue, dust, dew).

Saber Spot GO Frost Filter Installation

The Saber Spot GO comes with 2 frost filters. Before installation, peel off the adhesive backing on

both sides of the lens. Install the frost filter in front of the main lens (1 & 2). Insert the inlcuded retainer

ring by “squeezing” the ring and gently sliding it in place in front of the newly installed lens (3).

2. 3.