User manual
ADJ Products, LLC - www.adj.com - Saber Spot GO User Manual Page 20
Saber Spot GO ADJ UC IR/ Airstream IR Control
The ADJ UC IR (not included) infrared remote gives you control of various functions (See below).
To control the Saber Spot GO you must aim the remote at the front of the fixture and be no more
than 30 feet away. To use the ADJ UC IR you must first activate the fixtures infrared sensor, to activate
the sensor please see the instructions on page 18.
The ADJ Airstream IR remote transmitter (not included) plugs into the headphone jack of your iOS
phone or tablet. To control your fixture, raise the volume to the maximum level on your iOS phone or
tablet, aim the transmitter at the fixture sensor, and be no more than 15 feet away. The Airstream app
is a free download from the app store for your iOS phone or tablet. The app comes with 3 pages of
control depending on the fixture you are using. Please see below for IR functions including the cor-
responding app page.
Works with App page 1
STAND BY
Pressing this button will switch between IR remote control and DMX control.
FULL ON
Press this button to activate blackout. Press the button again to fully light up the unit. Pressing this
button will also exit strobing.
FADE/GOBO
Press this button to activate show mode. Continue to press this button to scroll through the different
shows.
DIMMER “+” and DIMMER “-”
Press these buttons to adjust the strobing rate when strobe is active.
STROBE
Press this button to activate strobing.
COLOR
Press this button activate static color mode. Continue to press this button to scroll through the available
colors.
1-9
These buttons are invalid for this fixture.
SOUND ON & OFF
These buttons are invalid for this fixture.
SHOW 0
This button is invalid for this fixture.
Standby
FullON Fade/Gobo
Strobe Color
1 2 3
4 5 6
7 8 9
SoundOn Show0 SoundO
(NOT INCLUDED)
BUTTONS