User manual
ADJ Products, LLC - www.adj.com - Saber Spot GO User Manual Page 18
Autolock - This function will lock the control panel after a minute of no use. Press the
MODE button for at least 7 seconds to unlock.
1. Press either the MODE, UP, or DOWN buttons until “AUTOLOCK” is displayed, press ENTER.
2. The display will show either “ON” or “OFF”. Press the UP or DOWN buttons to select “ON” to
have the keys lock after 10 seconds, or “OFF” so that the keys will remain unlocked.
3. Press the ENTER button to conrm.
IR Active - This function you can activate the IR function and use the UC IR or Airstream app
to control the unit.
1. Press either the MODE, UP, or DOWN buttons until “IR Active” is displayed, press ENTER.
2. The display will show either “ON” or “OFF”. Press the UP or DOWN buttons to select “ON” to
activate IR function, or “OFF” to turn o the IR function.
3. Press ENTER to conrm. See page 20 for the IR controls.
Flip Display - This function will reverse the display 180º.
1. Press either the MODE, UP, or DOWN buttons until “FlipDisplay” is displayed, press ENTER.
2. The display will show either “ON” or “OFF”. Press the UP or DOWN buttons to select “ON” to ip
the display, or “OFF” to keep the display normal.
3. Press the ENTER button to conrm.
WiFly Channel - This function you can set your desired WiFly channel. See WiFly Set Up
on page 19 for more information.
1. Press either the MODE, UP, or DOWN buttons until “WiFly Channel” is displayed, and press
ENTER.
2. Use the UP or DOWN buttons to nd your desired WiFly channel.
3. Press the ENTER button to conrm your WiFly channel.
Battery Power - This function you are able to check the remaining battery power.
1. Press either the MODE, UP, or DOWN buttons until “Fixture Power” is displayed, press ENTER.
2. The remaining battery charge will now be displayed. Press the MODE button to exit.
Runtime Mode - This function you are to adjust the battery running time. This adjustment
will change the output power as well. See page 19 for more information.
1. Press either the MODE, UP, or DOWN buttons until “Runtime Mode” is displayed, and press
ENTER.
2. Press the UP or DOWN buttons to nd your desired dimmer curve and press ENTER to conm.
Saber Spot GO Operating Instructions