User manual

ADJ Products, LLC - www.adj.com - Saber Spot GO User Manual Page 16
Saber Spot GO Operating Instructions
When making adjustments press ENTER to conrm your setup. To exit without making any
adjustments press the MODE button. The display will lock after 1 minute. Press the MODE
button for 7 seconds to unlock.
DMX MODE - DMX Address Setting.
1. Press either the MODE, UP, or DOWN buttons until “DMX MODE” is displayed, press ENTER.
2. The current address will now be displayed and ashing. Press the UP or DOWN buttons to nd
your desired address. Press the ENTER button to set your desired DMX address.
CHANNEL - This will let you select your desired DMX channel mode.
1. Press either the MODE, UP, or DOWN buttons until “CHANNEL” is displayed, press ENTER. The
current DMX channel mode will be displayed.
2. Press the UP or DOWN buttons to nd your desired DMX channel mode and press the ENTER
button to conm your setting.
SLAVE - This will let you set the unit as the slave unit in a master/slave conguration.
1. Press either the MODE, UP, or DOWN buttons until “Slave” is displayed.
LOOK - In this mode you are able to run 1 of 13 built-in programs.
1. Press either the MODE, UP, or DOWN buttons until “LOOK” is displayed, and press ENTER.
2. Use the UP or DOWN buttons to nd your desired program and press the ENTER button to conrm
your selection.
RESET - This function will return the unit to its default settings.
1. Press either the MODE, UP, or DOWN buttons until “Reset?” is displayed and press ENTER.
2. The display will show either “NO” or “YES”. Press the UP or DOWN buttons so that “YES” is displayed.
Press ENTER and the unit will reset back to default settings.
MANUAL - This function will allow you to manually adjust the RGBW output intensity and
strobe rate.
1. Press either the MODE, UP, or DOWN buttons until “Manual” is displayed, and press ENTER.
2. Use the UP or DOWN buttons scroll to the strobe setting and press ENTER. Use the UP or
DOWN buttons to set the strobe setting to value “255”, and press ENTER.
Note: The strobe settings follow the strobe values under DMX control mode.
3. Press the UP or DOWN buttons to nd the color you would like to adjust, and press ENTER. Use
the UP or DOWN buttons to make adjustments and press ENTER when nished.
4. Press the UP or DOWN buttons to continue to adjust the colors. To activate strobing, return to the
strobe setting and follow the values listed under “Shutter & Strobing” in DMX control on page 10.