User manual

ADJ Products, LLC - www.adj.com - Saber Spot GO User Manual Page 10
Saber Spot GO DMX Addressing
All xtures should be given a DMX starting address when using a DMX controller, so the correct xture
responds to the correct control signal. This digital starting address is the channel number from which
the xture starts to “listen” to the digital control signal sent out from the DMX controller. The assignment
of this starting DMX address is achieved by setting the correct DMX address on the digital control
display on the xture.
You can set the same starting address for all xtures or a group of xtures, or set dierent addresses
for each individual xture. Setting all xtures to the same DMX address will cause all xtures to react
in the same way, in other words, changing the settings of one channel will aect all the xtures
simultaneously.
If you set each xture to a dierent DMX address, each unit will start to “listen” to the channel number
you have set, based on the quantity of DMX channels of each xture. That means changing the settings
of one channel will only aect the selected xture.
In the case of the Saber Spot GO, when in 4 Channel you should set the starting DMX address of the
rst unit to 1, the second unit to 5 (4 + 1), the third unit to 9 (5 + 4), and so on. (See chart below for
more details.)
Channel Mode
Unit 1
Address
Unit 2
Address
Unit 3
Address
Unit 4
Address
3 Channels 1 4 7 10
4 Channels

1 5 9 13
4 Channels

1 5 9 13
9 Channels

1 10 19 28
11 Channels

1 12 23 34
12 Channels 1 13 25 37
7 Channels

1 8 15 22
8 Channels

1 9 17 25
8 Channels

1 9 17 25
5 Channels

1 6 11 16
6 Channels

1 7 13 19
6 Channels

1 7 13 19