Specifications

ADJ Products, LLC - www.adj.com - Inno Roll HP Instruction Manual Page 15
Operating Modes: The Inno Roll HP can operate in three dif-
ferent modes. In each mode you can run the fixture as a stand
alone fixture or in a master/slave confiugration. This next sec-
tion will detail the differences in the operating modes.
• Sound Active mode -
The fixture will react to sound, chasing through the built-in programs.
• Show mode -
The fixture will run one of 12 shows.
• DMX control mode -
This function will allow you to control each individual fixtures traits
with a standard DMX-512 controller such as the Elation® Show
Designer.
™
Universal DMX Control: This function allows you to use a Elation®
universal DMX-512 controller to control the chases and patterns,
dimmer and strobe. A DMX controller allows you to create unique
programs tailored to your individual needs.
1. The Inno Roll HP is an nine DMX channel DMX fixture. See
pages 18-20 for detailed description of the DMX values and traits.
2. To control your fixture in DMX mode, follow the set-up procedures
on pages 5-7 as well as the set-up specifications that are includ-
ed with your DMX controller.
3. Use the controller’s faders to control the various DMX fixture traits.
4. This will allow you to create your own programs.
5. Follow the instructions on page 9 to set the DMX address.
6. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
7. For help operating in DMX mode consult the manual included
with your DMX controller.
Sound Active Mode: This mode allows either single unit or several
units linked together, to run to the beat of the music.
1. Press the MENU button until “Sound Mode” is displayed, and
press ENTER. Press the UP or DOWN buttons so that “ON”
is displayed and press ENTER.
2. The sound sensitivity can be adjusted by pressing the MENU
button until “Sound Sense” is displayed. Press ENTER and use
the UP and DOWN buttons to adjust the sound sensitivity. “0”
Inno Roll HP Operation
ADJ Products, LLC - www.adj.com - Inno Roll HP Instruction Manual Page 14
Inno Roll HP Color & Gobo Adjustment
To enter the oset adjustment submenu, press the ENTER button for
at least 5 seconds. In this submenu you are able to adjust the original
position of the pan, gobo wheel, and color wheel.
Pan Oset - Adjustment of the Pan position.
1. Press the ENTER button for at least 5 seconds, then press the UP
or DOWN buttons so that “Pan Oset” is displayed, press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to conrm. Press the MENU button for one second
to exit.
Color Oset - Adjustment of the color wheel.
1. Press the ENTER button for at least 5 seconds, then press the UP
or DOWN buttons so that “Color Oset” is displayed, press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to conrm. Press the MENU button for one second
to exit.
Gobo Oset - Adjustment of the gobo wheel.
1. Press the ENTER button for at least 5 seconds, then press the UP
or DOWN buttons so that “Gobo Oset” is displayed, press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to conrm. Press the MENU button for one second
to exit.