Specifications

ADJ Products, LLC - www.adj.com - Inno Roll HP Instruction Manual Page 12 ADJ Products, LLC - www.adj.com - Inno Roll HP Instruction Manual Page 13
unit will automatically go into Master Slave mode.
• Blackout - If the DMX signal is lost or power is applied, the unit
will automatically go into stand by mode.
• Last State - If the DMX signal is lost the xture will stay in the
last DMX set up. If power is applied and this mode is set, the unit
will automatically go into the last DMX set up.
3. Press ENTER to conrm your desired set up.
Back Light - With this function you can make the back-
light automatically turn off after one minute.
1. Press the MENU button until “Back Light” is displayed, press
ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or
DOWN buttons to select “ON” to keep the backlight on at all
times, or “OFF” to allow the backlight to turn o after 2 minutes.
Press any button to turn the backlight on again.
3. Press ENTER to conrm.
Pan Invert - Pan Inversion
1. Press the MENU button until “Pan Invert” is displayed, press
ENTER. Either “Yes” or “No” will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons
until “Yes” is displayed, press ENTER to conm. To deactivate
Pan inversion, select “No” and press Enter.
Auto Test - This function will run a self test program.
1. Press the MENU button until “Auto Test” is displayed, press
ENTER.
2. The xture will now run a self test. Press the MENU button to
exit.
Inno Roll HP System Menu
Fixture Temp. - With this function you can display the
running temperature of the unit.
1. Tap the MENU button until “Fixture Temp.” is displayed,
press ENTER.
2. The current running temperature of the xture will now be
displayed. Press MENU to exit.
Function Hours - With this function you can display
the running time of the unit.
1. Press the MENU button until “Function Hours” is displayed,
press ENTER.
2. The running time of the xture will now be displayed. Press
MENU to exit.
Software Version - This will display the software ver-
sion.
1. Tap the MENU button until “Software Version” is displayed.
Press the ENTER button and the software vesion will be dis-
played.
2. Press the MENU button to leave this function.
Defaults - This will reset the unit to its default settings.
1. Tap the MENU button until “Defaults” is displayed. Press the
ENTER button and either “Yes” or “No” will be displayed.
2. Press the MENU button to leave this function.
Restart - Use this function to reset the unit.
1. Tap the MENU button until “Restart” is displayed, press
ENTER.
2. The xture will now reset.
Inno Roll HP System Menu