Specifications

ManualsBrandsADJ ManualsFlood LightH2O LED

©American DJ Supply® - www.americandj.com - H2O DMX PRO Instruction Manual Page 4

• To reduce the risk of electrical shock or re, do not expose this unit

rain or moisture

• Do not spill water or other liquids into or on to your unit.

• Do not attempt to operate this unit if the power cord has been

frayed or broken. Do not attempt to remove or break off the ground

prong from the electrical cord. This prong is used to reduce the risk

of electrical shock and re in case of an internal short.

• Disconnect from main power before making any type of connection.

• Do not remove the cover under any conditions. There are no user

serviceable parts inside.

• Never operate this unit when it’s cover is removed.

• Never plug this unit in to a dimmer pack

• Always be sure to mount this unit in an area that will allow proper

ventilation. Allow about 6” (15cm) between this device and a wall.

• Do not attempt to operate this unit, if it becomes damaged.

• This unit is intended for indoor use only, use of this product out`

doors voids all warranties.

• During long periods of non-use, disconnect the unit’s main power.

• Always mount this unit in safe and stable matter.

• Power-supply cords should be routed so that they are not likely to

be walked on or pinched by items placed upon or against them,

paying particular attention to the point they exit from the unit.

• Cleaning -The fixture should be cleaned only as recommended by

t he manufacturer. See page 14 for cleaning details.

• Heat -The appliance should be situated away from heat sources

such as radiators, heat registers, stoves, or other appliances (inclu-

d ing amplifiers) that produce heat.

• The fixture should be serviced by qualified service personnel

when:

A. The power-supply cord or the plug has been damaged.

B. Objects have fallen, or liquid has been spilled into the appliance.

C. The appliance has been exposed to rain or water.

D. The appliance does not appear to operate normally or exhibits a

marked change in performance.

H2O DMX PRO Safety Precautions H2O DMX PRO 52 Degree Lens Install

The install of the 52 Degree lens

is a pretty easy process. Please

be very carefull when doing this

install.

Unscrew and remove the focus

lens. Using your thumb, gently

push the lens outward until it

“pops” out.

When the lens “pops” out, the pic-

ture to the left is what you should

see. Remove the lens and retainer

ring.

Flip the focus lens barrel over and

insert the 52 degree lens. Care-

fully insert the retainer ring. Please

do this very carefully. Make sure

retainer ring is in correctly, esh

against the lens. Now you can

screw the focus lens back into the

H2O DMX PRO.