Instruction manual

©American DJ Supply® - www.americandj.com - H2O LED Instruction Manual Page 5 ©American DJ Supply® - www.americandj.com - H2O LED Instruction Manual Page 6
H2O LED Fuse Replacement
Warning: If after replacing the fuse you continue to blow fuses,
STOP using the unit. Contact customer support for further instruc-
tions, you may have to return the unit for servicing. Continuing to use
the unit may cause serious damage.
Fuse Replacement: Locate and remove the unit’s power cord. Once
the cord has been removed located the fuse holder located inside the
power socket. Insert a flat-head screw driver into the power socket
and gently pry out the fuse holder. Remove the bad fuse and replace
with a new one. The fuse holder has a built-in socket for a spare fuse
be sure not to confuse the spare fuse with active fuse.
Trouble Shooting: Listed below are a few common problems that you
may encounter, with solutions.
No light output from the unit;
1. Be sure you have connected your unit into a wall outlet with a
matching power supply.
2. Be sure the fuse has not blown. The fuse is located on the rear
panel near the power cord.
Unit does not color change;
1. Be sure the unit's toggle switch is in the lock position.
H2O LED Trouble Shooting
H2O LED 52 Degree Lens Install
The install of the 52 Degree lens
is a pretty easy process. Please
be very carefull when doing this
install.
Unscrew and remove the focus
lens. Using your thumb, gently
push the lens outward until it
“pops” out.
When the lens “pops” out, the pic-
ture to the left is what you should
see. Remove the lens and retainer
ring.
Flip the focus lens barrel over and
insert the 52 degree lens. Care-
fully insert the retainer ring. Please
do this very carefully. Make sure
retainer ring is in correctly, esh
against the lens. Now you can
screw the focus lens back into the
H2O LED.