User manual
ADJ Products, LLC - www.adj.com - FS600LED User Manual Page 10ADJ Products, LLC - www.adj.com - FS600LED User Manual Page 9
FS600LED Photometric Chart
FS600LED Trouble Shooting
FS600LED Cleaning
Listed below are a few common problems the user may encounter,
with solutions.
Unit not responding to DMX:
1. Check that the DMX cables are connected properly and are
wired correctly (pin 3 is “hot”; on some other DMX devices
pin 2 may be ‘hot’). Also, check that all cables are connected
to the right connectors; it does matter which way the inputs
and outputs are connected.
Due to fog residue, smoke, and dust cleaning the internal and exter-
nal optical lenses must be carried out periodically to optimize light
output.
1. Use normal glass cleaner and a soft cloth to wipe down the
outside casing.
2. Clean the external optics with glass cleaner and a soft cloth
every 20 days.
3. Always be sure to dry all parts completely before plugging
the unit back in.
Cleaning frequency depends on the environment in which the fixture
operates (i.e. smoke, fog residue, dust, dew).
FS600LED Fuse Replacement
The fuse holder located at the rear of the unit above the power cord.
Disconnect from the main power supply. Insert a standard flat head
screw driver in to the fuse holder housing, located on the back of the
unit. Turn the screwdriver in counter-clockwise direction to remove the
fuse holder. Remove the old fuse and discard it, replace the fuse with
the same type. Insert the fuse back into it’s housing.
The unit should be mounted using a mounting clamp (not provided),
afxing it to the mounting bracket that is provided with the unit.
Always ensure that the unit is rmly xed to avoid vibration and slip-
ping while operating. Always ensure that the structure to which you
are attaching the unit is secure and is able to support a weight of 10
times the unit’s weight. Also, always use a safety cable that can hold
12 times the weight of the unit when installing the xture.
The equipment must be installed by a professional, and it must be
installed in a place where it is out of the reach of people’s grasp.
FS600LED Installation