User manual
ADJ Products, LLC - www.adj.com - Encore Prole 1000 Color User Manual Page 12
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-
Slave setup. In a Master-Slave set up one unit will act as the control-
ling unit and the others will react to the controlling units built-in pro-
grams. Any unit can act as a Master or as a Slave however, only one
unit can be programmed to act as the “Master.”
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the
unit. Use standard XLR data cables to link your units together.
Remember that the Male XLR connector is the input and the
Female XLR connector is the ouput. The first unit in the chain
(master) will use the female XLR connector only. The last unit in
the chain will use the male XLR connector only.
2. Set the “Master” unit to your desired mode of operation.
3. On the “Slave” units press the MODE button until “Slave Mode” is
displayed. The unit is now set as the “Slave” unit. Each slave unit
must be set to the same setting.
4. Connect the rst “Slave” unit to the “Master”, and the “Slave” unit
should now start to follow the “Master”.
Encore Profile 1000 Color Master-Slave Configuration
Encore Profile 1000 Color Operating Instructions
PCB Temperature:
This will check the current temperature of unit as well as switch
between fahrenheit and celsius.
1. Plug the fixture in and press the MODE button until “OTHER
MODE” is displayed.
2. Press the SET UP button until “TEM:XXXX” is displayed.
3. Use the UP and DOWN buttons to switch between fahrenheit and
celsius.
Encore Profile 1000 Color Focus and Zoom Adjustments
The knobs located on the right side of unit are used to adjust the focus
and the zoom. For a tighter/narrow beam move the first/front knob to
the front of the fixture, and move the second knob to rear. For a wider
beam, move the first/front knob towards the middle of the fixture, and
move the second knob towards the middle as well. Adjust accordingly.
ADJ Products, LLC - www.adj.com - Encore Prole 1000 Color User Manual Page 19
Channel Value Function
8 COLOR MACROS/PROGRAMS/
AUTO RUN
COLOR CHANGE PROGRAMS
192 - 207 COLOR CHANGE 13
208 - 223 COLOR CHANGE 14
224 - 239 COLOR CHANGE 15
240 - 255 COLOR CHANGE 16
COLOR FADE PROGRAMS
0 - 15 COLOR FADE 1
16 - 31 COLOR FADE 2
32 - 47 COLOR FADE 3
48 - 63 COLOR FADE 4
64 - 79 COLOR FADE 5
80 - 95 COLOR FADE 6
96 - 111 COLOR FADE 7
112 - 127 COLOR FADE 8
128 - 143 COLOR FADE 9
144 - 159 COLOR FADE 10
160 - 175 COLOR FADE 11
176 - 191 COLOR FADE 12
192 - 207 COLOR FADE 13
208 - 223 COLOR FADE 14
224 - 239 COLOR FADE 15
240 - 255 COLOR FADE 16
9 PROGRAM SPEED
0 - 255 SLOW - FAST
10 DIMMER CURVES
0 - 20 STANDARD
21 - 40 STAGE
41 - 60 TV
61 - 80 ARCHITECTURAL
81 - 100 THEATRE
101 - 255 DEFAULT TO UNIT SETTING
Encore Profile 1000 Color 10 Channel Mode