User manual
ADJ Products, LLC - www.adj.com - Encore Prole 1000 Color User Manual Page 9
Encore Profile 1000 Color Operating Instructions
color you can activate strobing by pressing the SET UP button to
enter the strobe mode.
3. “STROB:XX” will be displayed, this is strobe mode. The strobing
can be adjusted between “00” (flash off) to “15” (fastest flash).
DMX Mode:
Operating through a DMX controller gives the user the freedom to
create their own programs tailored to their own individual needs.
The Encore Profile 1000 Color has 5 DMX modes: 4 channel mode,
5 channel mode, 6 channel mode, 10 channel mode, and 11 channel
mode. See page’s 14-22 for each mode’s DMX traits.
1. This function will allow you to control each individual fixture’s
traits with a standard DMX 512 controller.
2. To run your fixture in DMX mode press the MODE button until
“DMX MODE:XXX” is displayed. “XXX” represents the current
displayed DMX address. Use the UP or DOWN buttons to select
your desired DMX address, then press the SETUP button to select
your DMX channel mode.
3. Use the UP or DOWN buttons to scroll through the DMX channel
modes. The channel modes are listed below:
• “CHAN: 04” is 4 Channel DMX Mode.
• “CHAN: 05” is 5 Channel DMX Mode.
• “CHAN: 06” is 6 Channel DMX Mode.
• “CHAN: 10” is 10 Channel DMX Mode.
• “CHAN: 11” is 11 Channel DMX Mode.
4. Please see pages 14-22 for DMX values and traits.
5. After you have chosen your desired DMX Channel mode plug in
the fixture via the XLR connections to any standard DMX control-
ler.
System Reset:
This will return the fixture to its factory settings.
1. Plug the fixture in and press the MODE button until “OTHER
MODE” is displayed.
2. Press the SET UP button until “SYSRESET” is displayed.
3. Press the UP and DOWN buttons simultaneously to reset or press
the MODE button to exit.
ADJ Products, LLC - www.adj.com - Encore Prole 1000 Color User Manual Page 22
When Channel 7 is between the values of 0-51, Channels 1-4 are used, and
Channel 6 will control strobing.
When Channel 7 is between the values of 52-102, Channel 8 is in Color Macros
Mode, and Channel 6 will control strobing.
When Channel 7 is between the values of 103-153, Channel 8 is in Color Change
Mode, and Channel 9 will control the color change speed.
When Channel 7 is between the values of 154-204, Channel 8 is in Color Fade
Mode, and Channel 9 will control the color fade speed.
When Channel 7 is between the values of 205-255, Channel 8 is in Auto Run
Mode, and Channel 9 will control the Auto Run speed.
Channel Value Function
11 DIMMER CURVES
0 - 20 STANDARD
21 - 40 STAGE
41 - 60 TV
61 - 80 ARCHITECTURAL
81 - 100 THEATRE
101 - 255 DEFAULT TO UNIT SETTING
Encore Profile 1000 Color 11 Channel Mode