User manual
ADJ Products, LLC - www.adj.com - Encore Burst 100 IP User Manual Page 7
Encore Burst 100 IP Installation
Always ensure that the unit is rmly xed to avoid vibration and slipping while operating. Always
ensure that the structure to which you are attaching the unit is secure and is able to support a weight
of 10 times the unit’s weight. ALWAYS use safety cables that can hold 12 times the weight of the
unit when installing the xture.
This equipment must be installed by a professional, and it must be installed in a place where it is out
of the reach of people’s grasp.
Ensure ALL connections and end caps are properly sealed with a non-conductive dielectric
grease (available at most electrical suppliers) to prevent water ingress/condensation and/or
corrosion.
The Encore Burst 100 IP is fully operational in three dierent mounting positions; hanging upside-
down, mounted sideways on trussing, or set on a at level surface. Be sure this xture is kept at
least 12m (40ft) away from any ammable materials (decoration etc.).
Screw one clamp via a M12 screw and nut into the Omega bracket. Insert the quick-lock fasteners of
the Omega bracket into the respective holes of the adjustable mounting bracket. Tighten the quick-
lock fasteners fully clockwise. Pull the safety-cable through the opening located on the rear of the
unit and over the trussing system or a safe xation spot. Insert the end in the carabine and tighten
the safety screw. ALWAYS use and install the supplied safety cable as a safety measure to prevent
accidental damage and/or injury in the event the clamp fails.
CLAMP
OMEGA BRACKET
SAFETY CABLE
RIGGING POINT